Strona 1 z 2
wifi zrywa połączenie
: 10 września 2015, 09:05
autor: szybki
Debian Jessie. Program WiCd do obsługi połączeń, siła sygnału 100% (laptop stoi przy ruterze), zmieniłem kanał dla połączenia na inny niż mają rutery w okolicy. Problem polega na tym że zrywane jest połączenie co jakiś czas losowo i nie można się połączyć ponownie, pomaga jedynie zresetowanie całego laptopa. Próbowałem też ustawić połączenie na sztywno w /etc/network/interfaces jednak problem nie znika. Zauważyłem że nie ma tego problemu na windows i telefonie, więc to nie wina rutera.
Ma ktoś pomysł jak rozwiązać ten problem? Ogólnie to zrywanie połaczenia nawet by nie było uciażliwe, tylko problem w tym że aby nawiązać nowe, muszę resetować maszynę.
: 10 września 2015, 09:20
autor: pawkrol
Co się dzieje w logach wtedy?
Jaką masz kartę wifi?
Może jakiś skrypt powoduje down interfejsu wlan
: 10 września 2015, 09:29
autor: szybki
Nie ma nic w logach, są puste. Karta wifi, a jak to sprawdzić? Jakaś zwykła, fabryczna od lenovo g50-30. Skrypty? Hmm system jest czysty, zwykły openbox, nic więcej, poza tym up wlan nie pomaga.
: 10 września 2015, 09:56
autor: pawkrol
Najpierw przeczytaj Zakładając temat przeczytaj - łatwiej uzyskasz pomoc
Urządzenia PCI
Zobacz tez przed i po zerwaniu
logi po zerwaniu
: 10 września 2015, 11:36
autor: szybki
Kod: Zaznacz cały
lspci -k
00:00.0 Host bridge: Intel Corporation Atom Processor Z36xxx/Z37xxx Series SoC Transaction Register (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: iosf_mbi_pci
00:02.0 VGA compatible controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Graphics & Display (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: i915
00:13.0 SATA controller: Intel Corporation Device 0f23 (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: ahci
00:1a.0 Encryption controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Trusted Execution Engine (rev 0e)
Subsystem: Lenovo Device 3905
00:1b.0 Audio device: Intel Corporation Atom Processor Z36xxx/Z37xxx Series High Definition Audio Controller (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: snd_hda_intel
00:1c.0 PCI bridge: Intel Corporation Device 0f48 (rev 0e)
Kernel driver in use: pcieport
00:1c.2 PCI bridge: Intel Corporation Device 0f4c (rev 0e)
Kernel driver in use: pcieport
00:1c.3 PCI bridge: Intel Corporation Device 0f4e (rev 0e)
Kernel driver in use: pcieport
00:1d.0 USB controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series USB EHCI (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: ehci-pci
00:1f.0 ISA bridge: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Power Control Unit (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: lpc_ich
00:1f.3 SMBus: Intel Corporation Device 0f12 (rev 0e)
Subsystem: Lenovo Device 3905
02:00.0 Network controller: Realtek Semiconductor Co., Ltd. RTL8723BE PCIe Wireless Network Adapter
Subsystem: Lenovo Device b736
Kernel driver in use: rtl8723be
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 10)
Subsystem: Lenovo Device 3816
Kernel driver in use: r8169
Kod: Zaznacz cały
PRZED:
iwconfig
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID :o ff/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry short limit:7 RTS thr=2347 B Fragment thr :o ff
Encryption key :o ff
Power Management :o ff
lo no wireless extensions.
Kod: Zaznacz cały
PO:
iwconfig
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:"DOMX"
Mode:Managed Frequency:2.427 GHz Access Point: E8 :D E:27:43:F2:4A
Bit Rate=150 Mb/s Tx-Power=20 dBm
Retry short limit:7 RTS thr=2347 B Fragment thr :o ff
Encryption key :o ff
Power Management :o ff
Link Quality=70/70 Signal level=-4 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:13 Missed beacon:0
lo no wireless extensions.
PRZED:
http://pastebin.com/XbbjLE5Y
PO:
http://pastebin.com/tB6n3tCZ
syslog jest czysty
: 10 września 2015, 11:45
autor: pawkrol
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:"DOMX"
Mode:Managed Frequency:2.427 GHz Access Point: E8:8E:27:43:F2:4A
Bit Rate=150 Mb/s Tx-Power=20 dBm
Retry short limit:7 RTS thr=2347 B Fragment throff
Encryption key: off
Power Management: off
Link Quality=70/70 Signal level=-4 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:13 Missed beacon:0
lo no wireless extensions.
Jeśli to jest po zerwaniu to dziwne bo jest cały czas połączony.
Zastanowia mnie też ten wpis z dmesg
Kod: Zaznacz cały
[ 9871.884625] r8169 0000:03:00.0 eth0: link down
Łączysz się po kablu ?
Podaj po zerwaniu (Próbowałeś też wtedy puścić ping do routera?)
: 10 września 2015, 11:57
autor: szybki
Tak, łączę się po kablu czasami. Jednak to było odpalone na czysto wifi bez kabla.
Kod: Zaznacz cały
ifconfig
eth0 Link encap:Ethernet HWaddr 28:d2:44:a6:ff:5b
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
eth0:avahi Link encap:Ethernet HWaddr 28:d2:44:a6:ff:5b
inet addr:169.254.10.16 Bcast:169.254.255.255 Mask:255.255.0.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:42 errors:0 dropped:0 overruns:0 frame:0
TX packets:42 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:21396 (20.8 KiB) TX bytes:21396 (20.8 KiB)
wlan0 Link encap:Ethernet HWaddr 9c:ad:97:10:6f:6b
inet addr:192.168.1.106 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::9ead:97ff:fe10:6f6b/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:12673 errors:0 dropped:0 overruns:0 frame:0
TX packets:7857 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:17026971 (16.2 MiB) TX bytes:833414 (813.8 KiB)
Ping po zerwaniu jest normalny do rutera, poza tym że nie ma połączenia z zewnątrz np. google czy inną stroną.
: 10 września 2015, 11:59
autor: pawkrol
aaa to inna sprawa. To nie problem WIFI, a dns lub firewalla.
Zobacz czy po zerwaniu puścisz ping na 8.8.8.8
: 10 września 2015, 12:02
autor: szybki
Nie idzie. Czyli jak to naprawić?
edycja:
A ok, wpisałem DNSy od orange w wicd... to chyba to.
: 10 września 2015, 12:17
autor: pawkrol
a pokaż wynik polecenia oraz jaki błąd jest przy puszczeniu pinga do 8.8.8.8.
Router jaki masz ?
Kod: Zaznacz cały
route -n
iptables -L -nvx
cat /etc/network/interfaces