Przeczytałem co prawda http://www.cyberciti.biz/faq/find-out-l ... setserial/ oraz http://www.aboutdebian.com/modems.htm, ale niestety dalej mam problem z uruchomieniem modemu. Nie wiem jakich parametrów użyć w poleceniu setserial.
Kod: Zaznacz cały
lspci -vKod: Zaznacz cały
00:1f.6 Modem: Intel Corporation 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Modem Controller (rev 03) (prog-if 00 [Generic]) Subsystem: Toshiba America Info Systems Device 0001
Flags: bus master, medium devsel, latency 0, IRQ 4
I/O ports at 2400 [size=200]
I/O ports at 2000 [size=200]
Capabilities: [50] Power Management version 2
Kernel driver in use: Intel ICH ModemKod: Zaznacz cały
lspci -vvKod: Zaznacz cały
00:1f.6 Modem: Intel Corporation 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Modem Controller (rev 03) (prog-if 00 [Generic]) Subsystem: Toshiba America Info Systems Device 0001
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin B routed to IRQ 4
Region 0: I/O ports at 2400 [size=200]
Region 1: I/O ports at 2000 [size=200]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: Intel ICH ModemKod: Zaznacz cały
setserial -g /dev/ttyS*Kod: Zaznacz cały
/dev/ttyS0, UART: unknown, Port: 0x03e8, IRQ: 4
/dev/ttyS1, UART: unknown, Port: 0x02f8, IRQ: 3
/dev/ttyS2, UART: unknown, Port: 0x03e8, IRQ: 4
/dev/ttyS3, UART: unknown, Port: 0x02e8, IRQ: 3