Samoczynne roz

[mmica]

Witam,
mam pewien problem z połączeniem bezprzewodowym, a mianowicie - po starcie systemu, wicd łączy się z siecią bezprzewodową, ale połączenie jest bardzo niestabline. Teoretycznie problem rozwiązuje użycie

Kod: Zaznacz cały

# /etc/init.d/wicd restart

Po restarcie wszystko chodzi do czasu, gdy chcę połączyć się z inną siecią (albo rozłączyć i połączyć z aktualną), wtedy problem znów się pojawia. Zauważyłem też, że problem nie występuje gdy łączę się z siecią niezabezpieczoną, bądź zabezpieczoną WEP'em.

Debian Lenny, uname -a:

Kod: Zaznacz cały

 Linux new-age 2.6.26-2-686 #1 SMP Mon Aug 30 07:01:57 UTC 2010 i686 GNU/Linux

Karta sieciowa (działa na sterownikach z jądra [rt2500pci]):

Kod: Zaznacz cały

 05:00.0 Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01)

Wersja wicd'a: 1.6.2.2


W logach wpa_supplicant'a widnieją takie wpisy:

Kod: Zaznacz cały

WPA: Group rekeying completed with 00:24:fe:46:7a:29 [GTK=TKIP]
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
CTRL-EVENT-SCAN-RESULTS 
Trying to associate with 00:24:fe:46:7a:29 (SSID='mmica_network' freq=2427 MHz)
Authentication with 00:24:fe:46:7a:29 timed out.
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
CTRL-EVENT-SCAN-RESULTS 
[B]Trying to associate with 00:24:fe:46:7a:29 (SSID='mmica_network' freq=2427 MHz)
Associated with 00:24:fe:46:7a:29
WPA: Key negotiation completed with 00:24:fe:46:7a:29 [PTK=CCMP GTK=TKIP]
CTRL-EVENT-CONNECTED - Connection to 00:24:fe:46:7a:29 completed (reauth) [id=0 id_str=][/B]

A w dmesg:

Kod: Zaznacz cały

 [549453.988464] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[549454.034038] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[549454.900703] wlan0: Initial auth_alg=0
[549454.900718] wlan0: authenticate with AP 00:24:fe:46:7a:29
[549454.904513] wlan0: RX authentication from 00:24:fe:46:7a:29 (alg=0 transaction=2 status=0)
[549454.904523] wlan0: authenticated
[549454.904532] wlan0: associate with AP 00:24:fe:46:7a:29
[549454.957451] wlan0: authentication frame received from 00:24:fe:46:7a:29, but not in authenticate state - ignored
[549454.983029] wlan0: authentication frame received from 00:24:fe:46:7a:29, but not in authenticate state - ignored
[549455.104060] wlan0: associate with AP 00:24:fe:46:7a:29
[549455.304069] wlan0: associate with AP 00:24:fe:46:7a:29
[549455.504054] wlan0: association with AP 00:24:fe:46:7a:29 timed out
[549458.933899] wlan0: RX deauthentication from 00:24:fe:46:7a:29 (reason=1)
[549458.933899] wlan0: deauthenticated
[549463.176673] wlan0: Initial auth_alg=0
[549463.176688] wlan0: authenticate with AP 00:24:fe:46:7a:29
[549463.376058] wlan0: authenticate with AP 00:24:fe:46:7a:29
[549463.576059] wlan0: authenticate with AP 00:24:fe:46:7a:29
[549463.624939] wlan0: RX authentication from 00:24:fe:46:7a:29 (alg=0 transaction=2 status=0)
[549463.624939] wlan0: authenticated
[549463.624939] wlan0: associate with AP 00:24:fe:46:7a:29
[549463.627390] wlan0: authentication frame received from 00:24:fe:46:7a:29, but not in authenticate state - ignored
[549463.631928] wlan0: authentication frame received from 00:24:fe:46:7a:29, but not in authenticate state - ignored
[549463.643387] wlan0: authentication frame received from 00:24:fe:46:7a:29, but not in authenticate state - ignored
[B][549463.647721] wlan0: RX AssocResp from 00:24:fe:46:7a:29 (capab=0x411 status=0 aid=1)
[549463.647731] wlan0: associated
[549463.647751] wlan0: CTS protection enabled (BSSID=00:24:fe:46:7a:29)
[549463.648049] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[549474.520042] wlan0: no IPv6 routers present[/B]

*Częsci wytłuszczone przedstawiają stan po restarcie wicd'a.

Logi po podłączeniu karty:

Kod: Zaznacz cały

Sep 17 20:31:27 new-age kernel: [548365.832049] pccard: CardBus card inserted into slot 1
Sep 17 20:31:27 new-age kernel: [548366.051449] rt2500pci 0000:05:00.0: enabling device (0000 -> 0002)
Sep 17 20:31:27 new-age kernel: [548366.051469] ACPI: PCI Interrupt 0000:05:00.0[A] -> Link [C0C3] -> GSI 10 (level, low) -> IRQ 10
Sep 17 20:31:27 new-age kernel: [548366.080613] Registered led device: rt2500pci-phy25:radio
Sep 17 20:31:27 new-age kernel: [548366.108706] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:31:30 new-age kernel: [548369.292496] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
Sep 17 20:31:34 new-age kernel: [548373.081827] ADDRCONF(NETDEV_UP): eth0: link is not ready
Sep 17 20:31:34 new-age kernel: [548373.252758] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:31:34 new-age kernel: [548373.397286] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:31:35 new-age kernel: [548374.277644] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
Sep 17 20:32:03 new-age kernel: [548402.461541] ADDRCONF(NETDEV_UP): eth0: link is not ready
Sep 17 20:32:03 new-age kernel: [548402.523077] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:32:03 new-age kernel: [548402.572396] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:32:16 new-age kernel: [548414.848517] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
Sep 17 20:33:02 new-age kernel: [548461.463327] ADDRCONF(NETDEV_UP): eth0: link is not ready
Sep 17 20:33:02 new-age kernel: [548461.548464] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:33:03 new-age kernel: [548461.596389] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:33:03 new-age kernel: [548462.523890] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
Sep 17 20:33:45 new-age kernel: [548504.529446] ADDRCONF(NETDEV_UP): eth0: link is not ready
Sep 17 20:33:46 new-age kernel: [548504.647463] ADDRCONF(NETDEV_UP): wlan0: link is not ready
Sep 17 20:33:46 new-age kernel: [548504.694969] ADDRCONF(NETDEV_UP): wlan0: link is not ready

Z góry dzięki za rady! ;],
mmica

[DaVidoSS]

Odwiedź ten post może Ci pomoże..
http://debian.linux.pl/threads/19200-Ni ... post121251

[mmica]

DaVidoSS, tak też już próbowałem. Nie dało rady - dalej to samo, a więc wnioskuję, że wina leży raczej po stronie wpa_supplicanta (mało prawdopodobne) lub samych sterowników (bardziej prawdopodobne). Co ciekawe - na Ubuntu 10.04LTS wszystko działa jak marzenie. Próbowałem też z ndiswrapperem, ale nawet nie chciał połączyć się z siecią. Stanęło na tym, że kartę włożyłem do laptopa z Windows, a do siebie wziąłem Intela.

Dziękuję za chęci,
mmica