Strona 1 z 1

instalacja karty wifi agere systems

: 24 czerwca 2009, 00:36
autor: jaawor
Mam problem z zainstalowaniem karty wifi ,,agere systems'' pod Debianem.

Sam Debian został zainstalowany z płytki netinstall. Wersja minimalna, bez x-ów. Dodałem do niego fluxboksa, ale chciałbym żeby z internetem dało się połączyć pod konsolą (sieć zabezpieczona).

Diody kary wifi się nie zapalają, ,,power off''.

Oto parę zwracanych informacji:

Kod: Zaznacz cały

uname -r

Kod: Zaznacz cały

2.6.26-2-686

Kod: Zaznacz cały

cat /etc/apt/sources.list

Kod: Zaznacz cały

# deb cdrom:[Debian GNU/Linux 5.0.1 _Lenny_ - Official i386 NETINST Binary-1 20090413-22:27]/ lenny main

#deb cdrom:[Debian GNU/Linux 5.0.1 _Lenny_ - Official i386 NETINST Binary-1 20090413-22:27]/ lenny main

deb [url]http://ftp.pl.debian.org/debian/[/url] lenny main
deb-src [url]http://ftp.pl.debian.org/debian/[/url] lenny main

deb [url]http://security.debian.org/[/url] lenny/updates main
deb-src [url]http://security.debian.org/[/url] lenny/updates main

deb [url]http://volatile.debian.org/debian-volatile[/url] lenny/volatile main
deb-src [url]http://volatile.debian.org/debian-volatile[/url] lenny/volatile main

Kod: Zaznacz cały

lspci

Kod: Zaznacz cały

00:00.0 Host bridge: Intel Corporation 82855PM Processor to I/O Controller (rev
03)
00:01.0 PCI bridge: Intel Corporation 82855PM Processor to AGP Controller (rev 
3)
00:1d.0 USB Controller: Intel Corporation 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) 
SB UHCI Controller #1 (rev 03)
00:1d.1 USB Controller: Intel Corporation 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) 
SB UHCI Controller #2 (rev 03)
00:1d.2 USB Controller: Intel Corporation 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) 
SB UHCI Controller #3 (rev 03)
00:1d.7 USB Controller: Intel Corporation 82801DB/DBM (ICH4/ICH4-M) USB2 EHCI C
ntroller (rev 03)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev 83)
00:1f.0 ISA bridge: Intel Corporation 82801DBM (ICH4-M) LPC Interface Bridge (r
v 03)
00:1f.1 IDE interface: Intel Corporation 82801DBM (ICH4-M) IDE Controller (rev 
3)
00:1f.3 SMBus: Intel Corporation 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) SMBus Con
roller (rev 03)
00:1f.5 Multimedia audio controller: Intel Corporation 82801DB/DBL/DBM (ICH4/IC
4-L/ICH4-M) AC'97 Audio Controller (rev 03)
00:1f.6 Modem: Intel Corporation 82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Mod
m Controller (rev 03)
01:00.0 VGA compatible controller: ATI Technologies Inc Radeon Mobility M7 LW [
adeon Mobility 7500]
02:06.0 CardBus bridge: O2 Micro, Inc. OZ6933/711E1 CardBus/SmartCardBus Contro
ler (rev 01)
02:06.1 CardBus bridge: O2 Micro, Inc. OZ6933/711E1 CardBus/SmartCardBus Contro
ler (rev 01)
02:0e.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5705M Gigabit Et
ernet (rev 01)

Kod: Zaznacz cały

iwconfig

Kod: Zaznacz cały

lo        no wireless extensions.

eth0      no wireless extensions.

eth1      IEEE 802.11b  ESSID:""  Nickname:"HERMES I"
          Mode:Managed  Frequency:2.422 GHz  Access Point: Not-Associated   
          Bit Rate:11 Mb/s   Sensitivity:1/3  
          Retry limit:4   RTS thr :o ff   Fragment thr :o ff
          Encryption key :o ff
          Power Management :o ff
          Link Quality=0/92  Signal level=134/153  Noise level=134/153
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

Nie wiem za bardzo o co chodzi. w iwconfig, karta niby jest ale nie mam pojęcia jak połączyć się z internetem i dlaczego w lspci jej nie ma.