Walczę z problemem od kilku dni i nie daję rady, także zwracam się z prośbą o pomoc.
Próbuje skonfigurować internet poprzez komórkę, która podłączona jest przez kabelek do komputera. Teoretycznie powinno wszystko działać bo nie pojawia się żaden błąd połączenia, ale internetu nie ma, nie pinguje ani po IP ani np. http://www.wp.pl
Kod: Zaznacz cały
debian:/home/sebastian# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:1a:92:ee:30:3e  
          inet addr:192.168.0.124  Bcast:192.168.0.255  Mask:255.255.255.0
          inet6 addr: fe80::21a:92ff:feee:303e/64 Scope:Link              
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1              
          RX packets:297 errors:0 dropped:0 overruns:0 frame:0            
          TX packets:360 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:220285 (215.1 KiB)  TX bytes:95248 (93.0 KiB)
          Interrupt:20 Base address:0xb800
lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:160 errors:0 dropped:0 overruns:0 frame:0
          TX packets:160 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:11241 (10.9 KiB)  TX bytes:11241 (10.9 KiB)
ppp0      Link encap:Point-to-Point Protocol
          inet addr:172.23.35.141  P-t-P:10.6.6.6  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1500  Metric:1
          RX packets:4 errors:0 dropped:0 overruns:0 frame:0
          TX packets:5 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3
          RX bytes:52 (52.0 B)  TX bytes:73 (73.0 B)Kod: Zaznacz cały
nameserver 83.142.116.242
nameserver 192.168.0.1
domain enterpol.enterpol.pl
search enterpol.enterpol.plJeszcze wynik polecenia route:
Kod: Zaznacz cały
debian:/home/sebastian# route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
10.6.6.6              *               255.255.255.255 UH    0      0        0 ppp0
192.168.0.0        *               255.255.255.0   U     0      0        0 eth0
link-local            *               255.255.0.0     U     1000   0        0 eth0
default         192.168.0.1     0.0.0.0         UG    0      0        0 eth0Pytanie gdzie popełniłem błąd?