wifi zrywa po
wifi zrywa połączenie
Debian Jessie. Program WiCd do obsługi połączeń, siła sygnału 100% (laptop stoi przy ruterze), zmieniłem kanał dla połączenia na inny niż mają rutery w okolicy. Problem polega na tym że zrywane jest połączenie co jakiś czas losowo i nie można się połączyć ponownie, pomaga jedynie zresetowanie całego laptopa. Próbowałem też ustawić połączenie na sztywno w /etc/network/interfaces jednak problem nie znika. Zauważyłem że nie ma tego problemu na windows i telefonie, więc to nie wina rutera.
Ma ktoś pomysł jak rozwiązać ten problem? Ogólnie to zrywanie połaczenia nawet by nie było uciażliwe, tylko problem w tym że aby nawiązać nowe, muszę resetować maszynę.
Ma ktoś pomysł jak rozwiązać ten problem? Ogólnie to zrywanie połaczenia nawet by nie było uciażliwe, tylko problem w tym że aby nawiązać nowe, muszę resetować maszynę.
Najpierw przeczytaj Zakładając temat przeczytaj - łatwiej uzyskasz pomoc
Urządzenia PCI
Zobacz tez przed i po zerwaniu
logi po zerwaniu
Urządzenia PCI
Kod: Zaznacz cały
lspci -k
Kod: Zaznacz cały
iwconfig
Kod: Zaznacz cały
dmesg
/var/log/syslog
Kod: Zaznacz cały
lspci -k
00:00.0 Host bridge: Intel Corporation Atom Processor Z36xxx/Z37xxx Series SoC Transaction Register (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: iosf_mbi_pci
00:02.0 VGA compatible controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Graphics & Display (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: i915
00:13.0 SATA controller: Intel Corporation Device 0f23 (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: ahci
00:1a.0 Encryption controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Trusted Execution Engine (rev 0e)
Subsystem: Lenovo Device 3905
00:1b.0 Audio device: Intel Corporation Atom Processor Z36xxx/Z37xxx Series High Definition Audio Controller (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: snd_hda_intel
00:1c.0 PCI bridge: Intel Corporation Device 0f48 (rev 0e)
Kernel driver in use: pcieport
00:1c.2 PCI bridge: Intel Corporation Device 0f4c (rev 0e)
Kernel driver in use: pcieport
00:1c.3 PCI bridge: Intel Corporation Device 0f4e (rev 0e)
Kernel driver in use: pcieport
00:1d.0 USB controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series USB EHCI (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: ehci-pci
00:1f.0 ISA bridge: Intel Corporation Atom Processor Z36xxx/Z37xxx Series Power Control Unit (rev 0e)
Subsystem: Lenovo Device 3905
Kernel driver in use: lpc_ich
00:1f.3 SMBus: Intel Corporation Device 0f12 (rev 0e)
Subsystem: Lenovo Device 3905
02:00.0 Network controller: Realtek Semiconductor Co., Ltd. RTL8723BE PCIe Wireless Network Adapter
Subsystem: Lenovo Device b736
Kernel driver in use: rtl8723be
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 10)
Subsystem: Lenovo Device 3816
Kernel driver in use: r8169
Kod: Zaznacz cały
PRZED:
iwconfig
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID :o ff/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry short limit:7 RTS thr=2347 B Fragment thr :o ff
Encryption key :o ff
Power Management :o ff
lo no wireless extensions.
Kod: Zaznacz cały
PO:
iwconfig
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:"DOMX"
Mode:Managed Frequency:2.427 GHz Access Point: E8 :D E:27:43:F2:4A
Bit Rate=150 Mb/s Tx-Power=20 dBm
Retry short limit:7 RTS thr=2347 B Fragment thr :o ff
Encryption key :o ff
Power Management :o ff
Link Quality=70/70 Signal level=-4 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:13 Missed beacon:0
lo no wireless extensions.
PO: http://pastebin.com/tB6n3tCZ
syslog jest czysty
Jeśli to jest po zerwaniu to dziwne bo jest cały czas połączony.eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:"DOMX"
Mode:Managed Frequency:2.427 GHz Access Point: E8:8E:27:43:F2:4A
Bit Rate=150 Mb/s Tx-Power=20 dBm
Retry short limit:7 RTS thr=2347 B Fragment throff
Encryption key: off
Power Management: off
Link Quality=70/70 Signal level=-4 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:13 Missed beacon:0
lo no wireless extensions.
Zastanowia mnie też ten wpis z dmesg
Kod: Zaznacz cały
[ 9871.884625] r8169 0000:03:00.0 eth0: link down
Podaj po zerwaniu (Próbowałeś też wtedy puścić ping do routera?)
Kod: Zaznacz cały
ifconfig
Tak, łączę się po kablu czasami. Jednak to było odpalone na czysto wifi bez kabla.
Ping po zerwaniu jest normalny do rutera, poza tym że nie ma połączenia z zewnątrz np. google czy inną stroną.
Kod: Zaznacz cały
ifconfig
eth0 Link encap:Ethernet HWaddr 28:d2:44:a6:ff:5b
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
eth0:avahi Link encap:Ethernet HWaddr 28:d2:44:a6:ff:5b
inet addr:169.254.10.16 Bcast:169.254.255.255 Mask:255.255.0.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:42 errors:0 dropped:0 overruns:0 frame:0
TX packets:42 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:21396 (20.8 KiB) TX bytes:21396 (20.8 KiB)
wlan0 Link encap:Ethernet HWaddr 9c:ad:97:10:6f:6b
inet addr:192.168.1.106 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::9ead:97ff:fe10:6f6b/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:12673 errors:0 dropped:0 overruns:0 frame:0
TX packets:7857 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:17026971 (16.2 MiB) TX bytes:833414 (813.8 KiB)
a pokaż wynik polecenia oraz jaki błąd jest przy puszczeniu pinga do 8.8.8.8.
Router jaki masz ?
Router jaki masz ?
Kod: Zaznacz cały
route -n
iptables -L -nvx
cat /etc/network/interfaces